Raytheon NautoPilot NP 5100 Operator's Manual page 139

AS application
HAND
Edition: September 2014
NautoPilot 5000 Series
Activating a "Tiller" (no NautoSteer Tiller) with an override
function, switches the Autopilot to Override mode.
Observe section 1.4.8.
Note:
Tiller
The Autopilot can be activated at the connected Override
Operator Panel and starts in "Heading Control" mode at
once.
The lower LED will light up.
The mode change is displayed at the top right corner of the
display (Track Ctrl.  Override).
Switching the "Main Steering Switch" into position HAND,
AUTO
switches the Autopilot to "Manual".
No LED for activated control mode will light up.
The mode change is displayed at the top right corner of the
display (Track Ctrl.  Manual).
Activating a NautoSteer steering device (Tiller AS or Hand-
wheel AS) with an Override Operator Unit AS, switches the
Autopilot to Override mode.
Observe section 1.4.8.
Tiller
Note:
An activation of the Autopilot with the Override Operator Unit
AS (button Autopilot), switches the Autopilot into "Heading
Control".
The lower LED for standby will light up.
The mode change is displayed at the top right corner of the
display (Track Ctrl.  Override).
Activating a NautoSteer steering device (Tiller AS or Hand-
wheel AS) without an Override Operator Unit AS switches
the Autopilot control mode off.
Observe section 1.4.8.
Tiller
The lower LED for standby will light up yellow.
The mode change is displayed at the top right corner of the
display (Heading Ctrl.  Standby).
OPERATION
or
or
127
AUTOPILOT
4002.DOC010102