Raytheon NautoPilot NP 5100 Operator's Manual page 79

Table 9
Figure 33/1
Figure 33/2
Figure 33/3
Figure 33/4
Figure 33/5
Figure 33/6
Figure 33/7
Figure 33/8
Figure 33/9
Figure 33/10 Touch--icon, toggles resolution for the respective value.
Figure 33/11 Numerical display for the ruder angle in degrees, the arrows
Figure 33/12 Softkey for switching to "Setup Accel. Limit" display.
Figure 33/13 Softkey for switching to the first display (main page).
Figure 33/14 Softkeys for changing the selected acceleration limit
Figure 33/15 Softkey for switching back to the previous display, without a
Figure 33/16 Softkey for adjusting the threshold (in percent of adjusted
Edition: September 2014
OPERATION
NautoPilot 5000 Series
Softkeys for "Acceleration Monitor" display
Indication of max. speed (as calculated by the settings of accel-
eration limit, see next display "Setup Accel.Limit").
Indication of max. RoT (as limited by the settings of accelera-
tion limit, see next display "Setup Accel.Limit").
Indication of min. Radius (as calculated by the settings of ac-
celeration limit, see next display "Setup Accel.Limit").
Indication of actual speed.
Check box of currently selected RoT--limit adjusted on Main
Page. Check box is active if RoT--limit is activated. (see initial
display Figure 22).
Check box of currently selected RAD--limit (Radius) adjusted
on Main Page. Check box is active if RAD--limit is activated.
(see initial display Figure 22).
Indication of actual acceleration limit.
Information on heading source and actual heading value.
Set heading value.
For Course Control this display is designated as "Presel.COG"
(Preselected Course Over Ground) after turning the rotary
knob, "Set COG" after releasing the knob (in increments of 1
degree or 1/10 degree -- depends on selected resolution).
For Track Control this display is designated as "Track Course".
For Heading Control this display is designated as "Set Head-
ing".
next to this display show the direction of the rudder angle.
parameters. Changes must be acknowledged with "SET" (a
small icon is displayed after a change has been made see also
Figure 34).
transfer of changed values.
acceleration limit). An overshoot of this threshold leads to an
acoustic alarm at the Autopilot (only if the softkey "Warning" is
set to "on").
Value range: 50% to 100%/ (in increments of 5%).
67
Function
AUTOPILOT
4002.DOC010102