Raytheon NautoPilot NP 5100 Operator's Manual page 164

No approache radius
given
----------------------------------------------
No approache rad
No connection to server
----------------------------------------------
No connection to server
No Course Control
available
----------------------------------------------
No Course Contro
No Gyro Heading Se-
lected
----------------------------------------------
No Gyro Heading
No Heading
----------------------------------------------
No Heading
4002.DOC010102
OPERATION
NautoPilot 5000 Series
Message
Only for
NautoPilot 5500.
Attempt to start Track
control mode but the
wheel--over--line radius
is not transmitted by the
ECDIS.
GUI has no connection
to the (internal) controller
(slave -- master)
Attempt to start Course
Control mode, but the
type of NautoPilot ap-
plication is not suitable
for this mode
(example NP 5100).
Attempt to start Course
Control mode or Track
control mode but mag-
netic compass is se-
lected.
Wrong operator input.
No heading data from
external sensor.
Attempt to start Track
control mode but there is
no heading data.
Attempt to start Course
control but there is no
heading data.
Possible cause
152
Remedy
Initialise the Track con-
trol mode again. Check
the ECDIS.
See also Service
Manual.
-- Check network
configuration.
-- Check ethernet
connection.
Check type of Autopilot.
Check configuration and
license key.
Check Heading selection
(operator's input/adjust-
ment)
(see section 2.3.6.1).
Selected heading sensor
must be a gyro com-
pass.
-- Check operator's
input/adjustment
(see section 2.3.6.1).
-- Reset Autopilot
Operator Unit by
switching off the
supply voltage or by
removing the fuse.
-- Check heading
sensor(s).
Check heading sen-
sor(s).
Check heading sen-
sor(s).
Edition: September 2014