Raytheon NautoPilot NP 5100 Operator's Manual page 131

Preselected COG
Set Course Over Ground
Caution!
"Course Approaching" is displayed at the top bar of the display.
Rotary knob is disabled and a new set course over ground input is not pos-
sible while the heading change manoeuvre is running.
If set course over ground value is reached the caution "Course Approaching"
is no longer displayed. Now it is possible to make a new course change ma-
noeuvre.
Please note:
-- It is necessary to observe the Autopilot control function after heading change.
Edition: September 2014
OPERATION
NautoPilot 5000 Series
"Course Control" mode is active.
The mode is displayed at the top right corner of the dis-
play (Course Ctrl.).
Turning the rotary knob will change the set Course Over
Ground value.
Observe the 5 restriction.
Please note: After approx. 15 seconds of inactivity from
the rotary knob, the previous Course Over Ground value
is displayed again.
125.8
This value is displayed in italic and inverted colors.
The "SET" LED (near the button) is flashing (request to
press the "SET" button).
Pressing the rotary knob transmits the preselected value
to the controller as the new "Set Course Over Ground".
The value is now displayed in non--italics and normal col-
ors.
125.8
The "SET" LED (near the button) is off.
119
AUTOPILOT
4002.DOC010102