D-Link DES-3010F Command Line Interface Manual page 97

show loopdetect ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the loopback detection parameters:
DES-3026:4#show loopdetect ports 1-5
Command: show loopdetect ports 1-5
Port
--------
1
2
3
4
5
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r
Refresh
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#config loopdetect ports 1-10
state enable
Command: config loopdetect ports 1-10
state enable
Success.
DES-3026:4#
Used to display the Loopback Detection port settings on the switch.
show loopdetect ports {<portlist>}
This command will display the loopdetect port settings currently set
on the switch.
<portlist> – Enter a port or range of ports to be displayed. Not
entering this parameter will display all ports on the switch.
None.
Loopdetect State
-------------------------
Enabled
Enabled
Enabled
Enabled
Disabled
Loop status
-------------------
Normal
Normal
Normal
Normal
Normal
93