D-Link DES-3010F Command Line Interface Manual page 176

Command
config 802.1x fwd_pdu system
config 802.1x fwd_pdu ports
Each command is listed, in detail, in the following sections.
enable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable 802.1x switch wide:
DES-3026:4#enable 802.1x
Command: enable 802.1x
Success.
DES-3026:4#
disable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable 802.1x on the Switch:
DES-3026:4#disable 802.1x
Command: disable 802.1x
Success.
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
[enable|disable]
[<portlist>|all] [enable|disable]
NOTE: The uplink module ports (DES-3010F/FL/G ports 9-10, DES-3018
ports 17-18, DES-3026 ports 25-26) do not support the 802.1X function.
Used to enable the 802.1x server on the Switch.
enable 802.1x
The enable 802.1x command enables the 802.1x Port-based or MAC-
based Network Access control server application on the Switch.
None.
Only Administrator-level users can issue this command.
Used to disable the 802.1x server on the Switch.
disable 802.1x
The disable 802.1x command is used to disable the 802.1x Port-based or
MAC-based Network Access control server application on the Switch.
None.
Only Administrator-level users can issue this command.
172