D-Link DES-3010F Command Line Interface Manual page 199

config time_zone
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure time zone settings:
DES-3026:4#config time_zone operator + hour 2 min
30
Command: config time_zone operator + hour 2 min 30
Success.
DES-3026:4#
config dst
Purpose
Syntax
Description
Parameters
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#config time 30062003 16:30:30
Command: config time 30062003 16:30:30
Success.
DES-3026:4#
Used to determine the time zone used in order to adjust the system clock.
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
This will adjust system clock settings according to the time zone. Time zone
settings will adjust SNTP information accordingly.
operator – Choose to add (+) or subtract (-) time to adjust for time zone
relative to GMT.
hour – Select the number hours offset from GMT (Greenwich Mean Time).
min – Select the number of minutes difference added or subtracted to
adjust the time zone.
Only Administrator-level users can issue this command.
Used to enable and configure time adjustments to allow for the use of Daylight
Savings Time (DST).
config dst [disable | repeating {s_week <start_week 1-4,last> | s_wday
<start_weekday sun-sat>| s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_week <end_week 1-4,last> | e-wday <end_weekday sun-sat> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time
<start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> |
e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
DST can be enabled and configured using this command. When enabled this will
adjust the system clock to comply with any DST requirement. DST adjustment
effects system time for both manually configured time and time set using SNTP
service.
disable – Disable the DST seasonal time adjustment for the Switch.
repeating – Using repeating mode will enable DST seasonal time adjustment.
Repeating mode requires that the DST beginning and ending date be specified
195