Introduction - D-Link DES-3010F Command Line Interface Manual

This document is a reference guide for all DES-3010F/DES-3010FL/DES-3010G/DES-3016/DES-3018/DES-3026 switches.
Throughout this manual, the DES-3026 Switch will be the Switch referred to for all examples and configuration information. All
DES-3010F/DES-3010FL /DES-3010G/DES-3016/DES-3018/DES-3026 switches contain the same information and posses the
same configuration capabilities. The difference between the switches resides in the port type and the port count only.
The DES-3026 Switch can be managed through the Switch's serial port, Telnet, or the Web-based management agent. The
Command Line Interface (CLI) can be used to configure and manage the Switch via the serial port or Telnet interfaces.
This manual provides a reference for all of the commands contained in the CLI. Configuration and management of the Switch via
the Web-based management agent is discussed in the User's Guide.
Accessing the Switch via the Serial Port
The Switch's serial port's default settings are as follows:

9600 baud

no parity

8 data bits

1 stop bit
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial port configured as above
is then connected to the Switch's serial port via an RS-232 DB-9 cable.
With the serial port properly connected to a management computer, the following screen should be visible. If this screen does not
appear, try pressing Ctrl+r to refresh the console screen.
Copyright(C) 2008 D-Link Corporation. All rights reserved.
UserName:
There is no initial username or password. Just press the Enter key twice to display the CLI input cursor  DES-3026:4#. This is
the command line where all commands are inputted.
Setting the Switch's IP Address
Each switch must be assigned its own IP Address, which is used for communication with an SNMP network manager or other
TCP/IP application (for example BOOTP, TFTP). The Switch's default IP address is 10.90.90.90. The default Switch IP address
can be changed to meet the specification of your networking address scheme.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and can be found on the
initial boot console screen – shown below.
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026 Fast Ethernet Switch Command Line Interface
Firmware: Build 4.20.B27
Figure 1-1. Initial CLI screen
1
1
I
NTRODUCTION