D-Link DES-3010F Command Line Interface Manual page 67

Example usage:
To configure the state of dhcp_relay option 61:
DES-3026:4# config dhcp_relay option_61 state enable
Command: config dhcp_relay option_61 state enable
Success
DES-3026:4#
config dhcp_relay option_61 add
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add dhcp_relay option 61 rule:
DES-3026:4# config dhcp_relay option_61 add mac_address 00-11-22-
33-44-55 drop
Command: config dhcp_relay option_61 add mac_address 00-11-22-33-
44-55 drop
Success
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to add a rule for dhcp_relay option_61.
config dhcp_relay option_61 add [mac_address <macaddr>
|string <desc 255>] [relay <ipaddr>| drop]
This command adds a rule to determine the relay server based on
option 61. The matching rule can be based on either MAC address
or a user-specified string. Only one relay server can be specified for
a MAC-address or a string. If relay servers are determined based on
option 60, and one relay server is determined based on option 61,
the final relay servers will be the union of these two sets of the
servers.
mac-address – The client's client-ID which is the hardware address
of client.
string – The client's client-ID, which is specified by administrator.
drop – Specify to drop the packet.
relay – Specify to relay the packet to an IP address.
Only Administrator-level users can issue this command.
63