D-Link DES-3010F Command Line Interface Manual page 139

DES-3026:4#show link_aggregation algorithm
Command: show link_aggregation algorithm
Link Aggregation Algorithm = mac_source
DES-3026:4#
config lacp_ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure LACP port mode settings:
DES-3026:4#config lacp_port 1-6 mode active
Command: config lacp_port 1-6 mode active
Success.
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to configure settings for LACP compliant ports.
config lacp_ports <portlist> mode [active | passive]
This command is used to configure ports that have been previously
designated as LACP ports (see create link_aggregation).
<portlist>  Specifies a range of ports to be configured for LACP.
mode – Select the mode to determine if LACP ports will process LACP
control frames.

active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant
devices to negotiate the aggregated link so the group may be
changed dynamically as needs require. In order to utilize the
ability to change an aggregated port group, that is, to add or
subtract ports from the group, at least one of the participating
devices must designate LACP ports as active. Both devices
must support LACP.

passive – LACP ports that are designated as passive cannot
process LACP control frames. In order to allow the linked
port group to negotiate adjustments and make changes
dynamically, at one end of the connection must have "active"
LACP ports (see above).
Only Administrator-level users can issue this command.
135