D-Link DES-3010F Command Line Interface Manual page 86

DES-3026:4#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address
------- ---------------
1 10.1.1.2
2 10.40.2.3
3 10.21.13.1
Total Entries : 3
DES-3026:4#
config log_save_timing
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure log timing:
DES-3026:4#config log_save_timing log_trigger
Command: config log_save_timing log_trigger
Warning: If too many logs are produced, the flash will be
worn down soon!!!
Success
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
Severity
---------
All
All
All
Used to configure automatic saving of log to Syslog host.
config log_save_timing [time_interval <min 1-65535> | on_demand |
log_trigger]
The config log_save_timing command is used to configure the terms of saving
Switch logs to designated hosts.
time_interval <min 1-65535>  Specifies the minimum interval between saves in
minutes.
on_demand – Specifies that logs are saved when requested by the host
receiving the log.
log_trigger – Specifies that logs are saved when previously configured triggers
require the log to be saved to the Syslog host. Use config syslog host command
to determine what triggers are used.
Only Administrator-level users can issue this command.
Facility UDP port
--------- --------
Local0 514
Local0 514
Local0 514
82
Status
--------
Disabled
Disabled
Disabled