D-Link DES-3010F Command Line Interface Manual page 107

config traffic trap
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure traffic control and enable broadcast storm control system wide:
show traffic control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display traffic control setting:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to configure traps for traffic control.
config traffic trap [none | storm_occurred | storm_cleared | both]
Use this to enable traffic storm trap messages.
none – Will send no Storm trap warning messages regardless of action
taken by the Traffic Control mechanism.
storm_occurred – Will send Storm Trap warning messages upon the
occurrence of a Traffic Storm only.
storm_cleared – Will send Storm Trap messages when a Traffic Storm
has been cleared by the Switch only.
both – Will send Storm Trap messages when a Traffic Storm has been
both detected and cleared by the Switch.
Only Administrator-level users can issue this command.
DES-3026:4#config traffic trap storm_occurred
Command: config traffic trap storm_occurred
Success.
DES-3026:4#
Used to display current traffic control settings.
show traffic control {<storm_grouplist>}
This command displays the current storm traffic control configuration on
the Switch.
<storm_grouplist> – Specify a port or range of ports to display. If
unspecified, all ports will be displayed.
None.
103