D-Link DES-3010F Command Line Interface Manual page 111

config cos mapping
Restrictions
Example usage:
To configure CoS to enable port-based CoS mapping:
DES-3026:4#config cos mapping port all port_mapping
Command: config cos mapping port all port_mapping
Success
DES-3026:4#
show cos mapping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display CoS mapping configuration:
DES-3026:4#show cos mapping port 1-3
Command: show cos mapping port 1-3
Port
-----------------------------------------------------
-
1
2
3
DES-3026:4#
config dscp_mapping
Purpose
Syntax
DES-3000 Series Layer 2 Switch CLI Reference Manual
mapping as defined by the class (class <class_id 0-3>).

ip – Specifies port-based CoS mapping on selected ports to be tos or dscp
mapping.

tos – Specifies CoS mapping for Type of Service (ToS) priority. Select the
ToS value (value <value 0 - 7>) and the class (class <class_id 0-3>)
Only Administrator-level users can issue this command.
Used to show CoS mapping.
show cos mapping {port <portlist> | all }
The show cos mapping displays information regarding CoS mapping enabled ports and
their mapping method.
<portlist>  Specified a range of ports to be displayed. If no parameter specified, all ports
priority settings will be shown.
None.
Port priority
off
off
off
To configure CoS mapping for DSCP (DiffServ) based priority.
config dscp_mapping dscp_value <0–63> [class <class_id 0-3>]
Ethernet_priority
802.1p
802.1p
802.1p
107
IP_priority
off
off
off