D-Link DES-3010F Command Line Interface Manual page 62

Example usage:
To display dhcp relay status:
DES-3026:4# show dhcp_relay ipif System
Command: show dhcp_relay ipif System
DHCP/BOOTP Relay Status
DHCP/BOOTP Hops Count Limit
DHCP/BOOTP Relay Time Threshold : 0
DHCP Relay Agent Information Option 82 State
DHCP Relay Agent Information Option 82 Check
DHCP Relay Agent Information Option 82 Policy : Replace
Interface
----------
System
Success.
DES-3026:4#
config dhcp_relay option_60 state
Purpose
Syntax
Description
Parameters
Restrictions
DES-3000 Series Layer 2 Switch CLI Reference Manual
Server 1 Server 2
------------ ------------
10.48.74.122 10.23.12.34
Used to config dhcp_relay opton_60 state.
config dhcp_relay option_60 state [enable|disable]
This decides whether dhcp_relay will process the DHCP option 60 or
not.
When option_60 is enabled, if the packet does not have option 60,
then the relay servers cannot be determined based on option 60.
The relay servers will be determined based on either option 61 or
per IPIF configured servers.
If the relay servers are determined based on option 60 or option 61,
then per IPIF configured servers will be ignored.
If the relay servers are not determined either by option 60 or option
61, then per IPIF configured servers will be used to determine the
relay servers.
state – enable/disable

t
enable – he enable function of the dhcp_relay uses
option_60 rules to relay dhcp packets.

disable – the disable function of the dhcp_relay use
option_60 rules to relay dhcp packet
Only Administrator-level users can issue this command.
: Disabled
: 4
: Disabled
: Disabled
Server 3
------------
10.12.34.12
58
Server 4
------------
10.48.75.121