D-Link DES-3010F Command Line Interface Manual page 184

config radius add
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure RADIUS server communication settings:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Command: config 802.1x reauth port_based ports
1-18
Success.
DES-3026:4#
Used to configure the settings the Switch will use to communicate with a
RADIUS server.
config radius add <server_index 1-3> <server_ip> key <passwd 32>
[default | {auth_port <udp_port_number 1-65535> | acct_port
<udp_port_number 1-65535>}]
The config radius add command is used to configure the settings the
Switch will use to communicate with a RADIUS server.
<server_index 1-3>  Assigns a number to the current set of RADIUS
server settings. Up to 3 groups of RADIUS server settings can be entered
on the Switch.
<server_ip>  The IP address of the RADIUS server.
key  Specifies that a password and encryption key will be used between
the Switch and the RADIUS server.
 <passwd 32>  The shared-secret key used by the RADIUS
server and the Switch. Up to 32 characters can be used.
default  Returns all of the ports in the range to their default RADIUS
settings.
auth_port <udp_port_number 1-65535>  The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number 1-65535>  The UDP port number for
accounting requests. The default is 1813.
Only Administrator-level users can issue this command.
DES-3026:4#config radius add 1 10.48.74.121 key
tomato default
Command: config radius add 1 10.48.74.121 key
tomato default
Success.
DES-3026:4#
180