D-Link DES-3010F Command Line Interface Manual page 54

config smtp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the SMTP settings:
DES-3026:4#config smtp server 166.99.66.33 server_port 25 add
mail receiver dar_trem@nhl.com
Command: config smtp server 166.99.66.33 server_port 25 add
mail receiver dar_trem@nhl.com
Success.
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#disable smtp
Command: disable smtp
Success.
DES-3026:4#
Used to configure necessary information in setting up the Switch as
an SMTP client.
config smtp {server <ipaddr> | server_port <tcp_port_number 1-
65535> | self_mail_addr <mail_addr 64> | [add mail_receiver
<mail_addr 64> | delete mail_receiver <index 1-8>]}
This command will allow the user to set the necessary parameters to
configure the SMTP server and mail recipients. This command must
be completely configured properly for the SMTP function of the switch
to correctly operate.
server <ipaddr> – Enter the IP address of the SMTP server on a
remote device.
server_port <tcp_port_number 1-65535> – Enter the virtual port
number that the Switch will connect with on the SMTP server. The
common port number for SMTP is 25.
self_mail_addr <mail addr 64> – Enter the e-mail address from which
mail messages will be sent. This address will be the from address on
the e-mail message sent to a recipient. Only one self mail address
can be configured for this Switch. This string can be no more that 64
alphanumeric characters.
add mail_receiver <mail_addr 64> – Choose this parameter to add
mail recipients to receive e-mail messages from the Switch. Up to 8 e-
mail addresses can be added per Switch.
delete mail_receiver <index 1-8> – Choose this parameter to delete
mail recipients from the configured list receiving e-mail messages
from the Switch. Up to 8 e-mail addresses can be added per Switch.
Only Administrator-level users can issue this command.
50