D-Link DES-3010F Command Line Interface Manual page 144

DES-3026:4#create address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-04
Success.
DES-3026:4#
config address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a IP to MAC address binding entry on the Switch:
DES-3026:4#config address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-05
Command: config address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-05
Success.
DES-3026:4#
config address_binding ip_mac ports
Purpose
Syntax
Description
Parameters
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to configure a previously set IP-MAC address binding entry.
config address_binding ip_mac ipaddress <ipaddr>
mac_address <macaddr> {ports [<portlist> | all ] }
This command will configure an IP-MAC address binding entry.
<ipaddr> – The IP address of the device to be bound to the MAC
address stated below.
mac_address <macaddr> – The MAC address of the device to be
bound to the IP address stated above.
ports [<portlist> | all ] – The port or ports bound to the IP address
and MAC address stated above.
Only Administrator-level users can issue this command.
Used to enable ports on the Switch to be configured for IP-MAC address
binding.
config address_binding ip_mac ports [<portlist> | all] state [enable |
disable] allow_zeroip [enable | disable]
This command will configure ports as enabled or disabled for the IP-MAC
address binding function.
<portlist>  Specifies a port or range of ports to be enabled or disabled
for IP-MAC address binding.
all – Specifies all ports on the Switch are to be enabled or disabled for IP-
MAC address binding.
state – [enable | disable] – Enables or disables the specified range of
ports for IP-MAC address binding.
140