D-Link DES-3010F Command Line Interface Manual page 20

config serial_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the baud rate:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to configure the serial port.
{baud_rate [9600 | 19200 | 38400 | 115200] |auto_logout [never |
2_minutes | 5_minutes| 10_minutes | 15_minutes]}
This command is used to configure the serial port's baud rate and auto
logout settings.
baud rate [9600 | 19200 | 38400 | 115200]  The serial bit rate that will be
used to communicate with the management host.
auto_logout – This parameter will allow the user to choose the time the
Switch's serial port will be idle before automatically logging out. The user
may choose one of the following.
 never  No time limit on the length of time the console can be open
with no user input.
 2_minutes  The console will log out the current user if there is no
user input for 2 minutes.
 5_minutes  The console will log out the current user if there is no
user input for 5 minutes.
 10_minutes  The console will log out the current user if there is
no user input for 10 minutes.
 15_minutes  The console will log out the current user if there is
no user input for 15 minutes.
Only Administrator-level users can issue this command.
DES-3026:4#config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DES-3026:4#
16