D-Link DES-3010F Command Line Interface Manual page 138

DES-3026:4#config link_aggregation algorithm
mac_source_dest
Command: config link_aggregation algorithm
mac_source_dest
Success.
DES-3026:4#
show link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display Link Aggregation configuration:
DES-3026:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = mac_source
Group ID
Type
Master Port
Member Port
Active Port
Status
Flooding Port : 0
DES-3026:4#
Example Usage:
To display the link aggregation algorithm set on the switch.
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to display the current link aggregation configuration on the Switch.
show link_aggregation {group_id <value 1-3> | algorithm}
This command will display the current link aggregation configuration of the
Switch.
<value 1-3>  Specifies the group ID. The Switch allows up to 3 link
aggregation groups to be configured. The group number identifies each of
the groups. group_id 3 is designed for the uplink modules only (the last two
ports on the Switch (9-10, 17-18, 25-26) and cannot be viewed here.
algorithm  Displays the link aggregation algorithm in use on the Switch.
None.
: 1
: TRUNK
: 5
: 5-7
:
: Disabled
134