config ports
mdix – MDIX mode can be specified as auto, normal, and cross
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure the speed of ports 1-3 to be 10 Mbps, full duplex and state enabled:
DES-3026:4#config ports 1-3 speed 10_full state enable
Command: config ports 1-3 speed 10_full state enable
Success.
DES-3026:4#
show ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the configuration of ports 1-5 on the Switch:
DES-3026:4#show ports 1-5
Command: show ports 1-5
Port
State/
Mdix
---
--------
1
Enabled
Normal
2
Enabled
Normal
3
Enabled
Normal
4
Enabled
Normal
5
Enabled
Normal
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
Example usage:
To display port descriptions:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to display the current configuration of a range of ports.
show ports {<portlist>} {description | err_disabled}
This command is used to display the current configuration of a range
of ports.
<portlist> – Specifies a port or range of ports to be displayed.
description – Adding this parameter to the command will allow the
user to view previously configured descriptions set on various ports
on the Switch.
err_disabled – Used to view information about ports that have had
their connection status disabled, for reasons such as link down
status.
None.
Settings
Speed/Duplex/FlowCtrl
---------------------
Auto/Enabled
Auto/Enabled
Auto/Enabled
Auto/Enabled
Auto/Enabled
Connection
Speed/Duplex/FlowCtrl
---------------------
100/Full/none
Link Down
Link Down
Link Down
Link Down
25
Address
Learning
--------
Enabled
Enabled
Enabled
Enabled
Enabled