D-Link DES-3010F Command Line Interface Manual page 66

Example usage:
To show dhcp_relay option 60 rule:
DES-3026:4# show dhcp_relay option_60
Command: show dhcp_relay option_60
Default processing Mode: drop
Default Servers:
10.90.90.100
10.90.90.101
10.90.90.102
Mating Rules:
String
---------
abc
abcde
abcdefg
Total Entries
DES-3026:4#
config dhcp_relay option_61 state
Purpose
Syntax
Description
Parameters
Restrictions
DES-3000 Series Layer 2 Switch CLI Reference Manual
Match Type IP Address
------------- -----------
exact match 10.90.90.1
partial match 10.90.90.2
exact match 10.90.90.3
: 3
Used to config dhcp_relay opton_61 state.
config dhcp_relay option_61 state [enable|disable]
This function decides whether dhcp_relay will process the DHCP
option 61 or not. When option_61 is enabled, if the packet does not
have option 61, then the relay servers cannot be determined based
on option 61. If the relay servers are determined based on option 60
or option 61, then per IPIF configured servers will be ignored. If the
relay servers are not determined either by option 60 or option 61,
then per IPIF configured servers will be used to determine the relay
servers.
state – enable/disable

enable – enables
rules to relay dhcp packets.

disable – disables the function, dhcp_relay uses option_61
rules to relay dhcp packet
Only Administrator-level users can issue this command.
t
he function, dhcp_relay uses option_61
62