D-Link DES-3010F Command Line Interface Manual page 85

delete syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a previously configured syslog host:
show syslog host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show Syslog host information:
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#config syslog host all severity all
facility local0
Command: config syslog host all severity all
facility local0
Success.
DES-3026:4#
Used to remove a syslog host that has been previously configured,
from the Switch.
delete syslog host [<index 1-4> | all]
The delete syslog host command is used to remove a syslog host
that has been previously configured from the Switch.
<index 1-4>  Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
all  Specifies that the command will be applied to all hosts.
Only Administrator-level users can issue this command.
DES-3026:4#delete syslog host 4
Command: delete syslog host 4
Success.
DES-3026:4#
Used to display the syslog hosts currently configured on the Switch.
show syslog host {<index 1-4>}
The show syslog host command is used to display the syslog
hosts that are currently configured on the Switch.
<index 1-4>  Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
None.
81