D-Link DES-3010F Command Line Interface Manual page 47

create trusted_host
Parameters
Restrictions
Example usage:
To create the trusted host:
Example usage:
To create the trusted network:
show trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the list of trust hosts:
DES-3026:4#show trusted_host
Command: show trusted_host
Management Stations
IP Address
-----------------------
10.0.0.0/8
11.1.2.3
Total Entries: 1
DES-3000 Series Layer 2 Switch CLI Reference Manual
<ipaddr>  The IP address of the trusted host to be created.
network <network_address> – Users may enter this parameter to
configure a trusted network for the device, using an IP address with
the appropriate subnet mask.. (ex. If an IP address of 10. 53.13.1/8
was added here, it would constitute all address from 10.0.0.0 –
10.255.255.255 as trusted IP addresses, or in essence the whole 10
dot network.)
Only Administrator-level users can issue this command.
DES-3026:4#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DES-3026:4#
DES-3026:4#create trusted_host
Command: create trusted_host
Success.
DES-3026:4#
Used to display a list of trusted hosts entered on the Switch using
the create trusted_host command above.
show trusted_host
This command is used to display a list of trusted hosts entered on
the Switch using the create trusted_host command above.
None.
None.
network 11.0.0.0/8
network 11.0.0.0/8
43