D-Link DES-3010F Command Line Interface Manual page 167

config cpu access_profile
Parameters
profile_id <value 1-3>  Enter an integer used to identify the access profile that will be
configured with this command. This value is assigned to the access profile when it is created
with the create access_profile command. The profile ID sets the relative priority for the profile
and specifies an index number that will identify the access profile being created with this
command. Priority is set relative to other profiles where the lowest profile ID has the highest
priority.
add access_id <value 1-5>  Adds an additional rule to the above specified access profile.
The value is used to index the rule created.
ethernet  Specifies that the Switch will look only into the layer 2 part of each packet.
vlan <vlan_name 32>  Specifies that the access profile will apply to only to this VLAN.

source_mac <macaddr>  Specifies that the access profile will apply to this source MAC

address.
destination_mac <macaddr>  Specifies that the access profile will apply to this

destination MAC address.
802.1p <value 0-7>  Specifies that the access profile will apply only to packets with this

802.1p priority value.
ethernet_type <hex 0x0-0xffff>  Specifies that the access profile will apply only to

packets with this hexadecimal 802.1Q Ethernet type value in the packet header.
ip  Specifies that the Switch will look into the IP fields in each packet.
vlan <vlan_name 32>  Specifies that the access profile will apply to only this VLAN.

source_ip <ipaddr>  Specifies that the access profile will apply to only packets with this

source IP address.
destination_ip <ipaddr>  Specifies that the access profile will apply to only packets with

this destination IP address.
dscp <value 0-63>  Specifies that the access profile will apply only to packets that have

this value in their Type-of-Service (DiffServ code point, DSCP) field in their IP packet
header
icmp  Specifies that the Switch will examine the Internet Control Message Protocol

(ICMP) field within each packet.
igmp  Specifies that the Switch will examine the Internet Group Management Protocol

(IGMP) field within each packet.
tcp  Specifies that the Switch will examine the Transmission Control Protocol (TCP)

field within each packet.
protocol_id <value 0-255>  Specifies that the switch will examine the Protocol field in each
packet and if this field contains the value entered here, apply the following rules.
DES-3000 Series Layer 2 Switch CLI Reference Manual
type <value 0-255>  Specifies that the access profile will apply to this ICMP

type value.
code <value 0-255>  Specifies that the access profile will apply to this ICMP

code.
type <value 0-255>  Specifies that the access profile will apply to packets that

have this IGMP type value.
src_port <value 0-65535>  Specifies that the access profile will apply only to

packets that have this TCP source port in their TCP header.
dst_port <value 0-65535>  Specifies that the access profile will apply only to

packets that have this TCP destination port in their TCP header.
163