D-Link DES-3010F Command Line Interface Manual page 6

Boot Procedure
---------------------------------------------------------------------------
Power On Self Test ......................................100%
MAC Address : 00-13-46-ED-3E-78
H/W Version : A3
Please Wait, Loading V4.20.B27 Runtime Image.............55%
The Switch's MAC address can also be found in the Web management program on the Switch Information (Basic Settings)
window on the Configuration menu.
The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch IP address can be
automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the Switch must be known.
The IP address may be set using the Command Line Interface (CLI) over the console serial port as follows:
1. Starting at the
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x's represent the IP address to be assigned to the IP interface named
System and the y's represent the corresponding subnet mask.
2. Alternatively, you can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x's represent the IP address to
be assigned to the IP interface named System and the z represents the corresponding number of subnets in CIDR
notation.
The IP interface named System on the Switch can be assigned an IP address and subnet mask which can then be used to connect a
management station to the Switch's Telnet or Web-based management agent.
Copyright(C) 2008 D-Link Corporation. All rights reserved.
UserName:
PassWord:
DES-3026:4#config ipif System ipaddress 10.73.21.42/255.0.0.0
Command: config ipif System ipaddress 10.73.21.42/8
Success
DES-3026:4#_
In the above example, the Switch was assigned an IP address of 10.73.21.42 with a subnet mask of 255.0.0.0 (8 in CIDR from).
The system message Success indicates that the command was executed successfully. The Switch can now be configured and
managed via Telnet and the CLI or via the Web-based management agent using the above IP address to connect to the Switch.
DES-3000 Series Layer 2 Switch CLI Reference Manual
Figure 1-2. Boot Screen
command line prompt,
DES-3026 Fast Ethernet Switch Command Line Interface
Firmware: Build 4.20.B27
Figure 1-3. Assigning an IP Address
enter the commands
2
V1.01.009
config ipif System ipaddress