D-Link DES-3010F Command Line Interface Manual page 205

System
System
System
System
System
System
System
System
System
System
Total Entries = 20
DES-3026:4#
config arp_aging time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ARP aging time:
DES-3026:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DES-3026:4#
clear arptable
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
DES-3000 Series Layer 2 Switch CLI Reference Manual
10.17.42.153 00-80-C8-4D-4E-0A
10.19.72.100 00-50-BA-38-7D-5E
10.21.32.203 00-80-C8-40-C1-06
10.40.44.60 00-50-BA-6B-2A-1E
10.42.73.221 00-01-02-03-04-00
10.44.67.1 00-50-BA-DA-02-51
10.47.65.25 00-50-BA-DA-03-2B
10.50.8.7 00-E0-18-45-C7-28
10.90.90.90 00-01-02-03-04-00
10.255.255.255 FF-FF-FF-FF-FF-FF
Used to configure the age-out timer for ARP table entries on the Switch.
config arp_aging time <value 0-65535>
This command sets the maximum amount of time, in minutes, that an
ARP entry can remain in the Switch's ARP table, without being
accessed, before it is dropped from the table.
time <value 0-65535>  The ARP age-out time, in minutes. The value
may be set in the range of 0-65535 minutes with a default setting of 20
minutes.
Only Administrator-level users can issue this command.
Used to remove all dynamic ARP table entries.
clear arptable
This command is used to remove dynamic ARP table entries from
the Switch's ARP table. Static ARP table entries are not affected.
None.
Only Administrator-level users can issue this command.
201
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Dynamic
Local
Local/Broadcast