D-Link DES-3010F Command Line Interface Manual page 133

disable vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable VLAN trunk:
config vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure VLAN trunk ports 1-5:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Used to disable VLAN trunking on the switch.
disable vlan_trunk
Used to disable the VLAN trunking function on the switch.
None.
Only Administrator-level users can issue this command.
DES-3026:4# disable vlan_trunk
Command: disable vlan_trunk
Success
DES-3026:4#
Used to configure the VLAN trunk port members.
config vlan_trunk ports [<portlist>| all] | state [enable|disable]
This command is used to configure a port as a VLAN trunk port. By default
none of the ports are VLAN trunk ports.
A VLAN trunk port and a non-VLAN trunk port cannot be grouped as an
aggregated link. To change the settings for an aggregated link, the user
must apply the command from the master port. The user destroys the LA
port, the individual port settings will be determined by whether the VLAN
trunk is enabled or disabled.
<portlist>  Specifies the list of ports to be configured.
enabled  Specifies that the port is a VLAN trunk port.
disable  Specifies that the port is not a VLAN trunk port.
Only Administrator-level users can issue this command.
DES-3026:4#config vlan_trunk ports 1-
5 state enable
Command: config vlan_trunk ports 1-5
state enable
Success.
DES-3026:4#
129