D-Link DES-3010F Command Line Interface Manual page 120

DES-3026:4#show bandwidth_control 1-12
Command: show bandwidth_control 1-12
Bandwidth Control Table
Port
----
1
2
3
4
5
6
7
8
9
10
11
12
DES-3026:4#
config cos port_mapping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure CoS port mapping for a range of ports:
DES-3026:4#config cos port_mapping class 0 1-4
Command: config cos port_mapping class 0 1-4
Success
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
RX Rate (kbit/sec)
---------------------
100000
100000
100000
100000
100000
100000
100000
100000
100000
100000
no_limit
no_limit
Used to map a specific port to one of the hardware queues available on the
Switch.
config cos port_mapping [class <class_id 0 | 3>] [<portlist> | all ]
Use this command to configure port-to-class CoS mapping. Port mapping
must first be enabled using the command config cos mapping port
<portlist> port_mapping on the ports before this can be configured.
<class_id [0 | 3] >  Specifies to which of the Switch's hardware priority
classes of service value will be mapped for the port or ports. There are two
classes available for port COS mapping.
<portlist>  Specifies a port or range of ports to be configured.
all  Specifies that the mapping will be applied to all ports on the Switch.
Only Administrator-level users can issue this command.
TX_RATE (kbit/sec)
----------------------
100000
100000
100000
100000
100000
100000
100000
100000
100000
100000
no_limit
no_limit
116