config bandwidth_control
Parameters
Restrictions
Example usage:
To configure bandwidth control:
DES-3026:4#config bandwidth_control 1-10 rx_rate 100000
tx_rate 100000
Command: config bandwidth_control 1-10 rx_rate 100000
tx_rate 100000
Success.
DES-3026:4#
show bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display bandwidth control settings:
DES-3000 Series Layer 2 Switch CLI Reference Manual
<portlist> Specifies a port or range of ports to be configured for
bandwidth control.
rx_rate Specifies that one of the parameters below (no_limit or
<value 64-1024000>) will be applied to the rate at which the above
specified ports will be allowed to receive packets.
no_limit Specifies that there will be no limit on the rate of
packets received by the above specified ports.
<value 64-1024000> Specifies the packet limit, in kbps,
that the above ports will be allowed to receive.
tx_rate Specifies that one of the parameters below (no_limit or
<value 64-1024000>) will be applied to the rate at which the above
specified ports will be allowed to transmit packets.
no_limit Specifies that there will be no limit on the rate of
packets transmitted by the above specified ports.
<value 64-1024000> Specifies the packet limit, in kbps,
that the above ports will be allowed to transmit.
Only Administrator-level users can issue this command.
Used to display the bandwidth control configuration on the Switch.
show bandwidth_control {<portlist>}
The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
<portlist> Specifies a port or range of ports to be viewed.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the Switch stack.
None.
115