show loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the loopback detection parameters:
config loopdetect ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set ports 1-10 as loopdetect enabled ports:
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#config loopdetect interval 10
Command: config loopdetect interval 10
Success.
DES-3026:4#
Used to display the Loopback Detection function parameters set on
the switch.
show loopdetect
This command will display the loopdetect settings currently set on
the switch.
None.
None.
DES-3026:4#show loopdetect
Command: show loopdetect
Loopdetect Global Settings
-----------------------------------------
Loopdetect Status
Loopdetect Interval
Recover Time
DES-3026:4#
Used to enable ports on the Switch as loopback detection enabled.
config loopdetect ports [<portlist> | all] state [enable | disable]
This command enables switch ports for the loopdetect function.
ports <portlist> – Enter a port or range of ports to be set as
loopdetect ports.
all – Using this parameter will configure all ports on the switch as
loopback detection ports.
state [enable | disable] – Use this parameter to enable or disable the
selected ports as enabled for the loopback detection function.
Only Administrator-level users can issue this command.
: Enabled
: 10
: 60
92