show snmp traps
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the current SNMP trap support:
DES-3026:4#show snmp traps
Command: show snmp traps
SNMP Trap
Authenticate Traps
DES-3026:4#
config snmp system_contact
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch contact to "M I S D e p a r t m e n t I I ":
DES-3026:4#config snmp system_contact MIS
Department II
Command: config snmp system_contact MIS Department
II
Success.
DES-3026:4#
DES-3000 Series Layer 2 Switch CLI Reference Manual
DES-3026:4#
Used to show SNMP trap support on the Switch .
show snmp traps
This command is used to view the SNMP trap support status
currently configured on the Switch.
None.
Only Administrator-level users can issue this command.
Used to enter the name of a contact person who is responsible for
the Switch.
config snmp system_contact {<sw_contact>}
The config snmp system_contact command is used to enter the
name and/or other information to identify a contact person who is
responsible for the Switch. A maximum of 255 characters can be
used.
<sw_contact> – A maximum of 255 characters is allowed. A NULL
string is accepted if there is no contact.
Only Administrator-level users can issue this command.
: Enabled
: Enabled
46