Table of Contents
Advertisement
7462
MFP stapler assembly tamper drive motor assembly removal
1. Remove the top cover. See
2. Pull slack in the tamper drive belt and remove the belt from the tamper drive belt pulley.
3. Disconnect the tamper driver motor harness from the controller card.
4. Remove the two screws (A) securing the tamper drive motor assembly to the tamper frame.
5. Remove the tamper drive motor assembly.
MFP stapler assembly media stack flap and media stack flap actuator removal
1. Remove the handle cover. See
2. Release the locking tab and slide the media stack flap actuator to the right and remove.
4-210
Service Manual
"MFP stapler assembly top cover removal" on page
"MFP stapler assembly handle cover removal" on page
4-204.
A
4-205.
Previous
Next
Go Back
Advertisement
Table of Contents
