Punch Unit Motor Assembly Removal - Lexmark W850n Manual

Punch unit motor assembly removal

1.
Open the finisher front door assembly.
2.
Remove the rear upper cover.
3.
Remove the punch carriage assembly. See
4.
Disconnect the connector from the punch unit motor assembly (A).
5.
Disconnect the connector from the sensor (punch unit motor encoder) (B).
6.
Remove the harness from the clamp.
7.
Remove the two screws securing the punch unit motor assembly (A) to the punch unit assembly (C).
Connector
8.
Remove the punch unit motor assembly.
See"Rear upper cover removal" on page
"Punch carriage assembly removal" on page
B
Clamp
4024-110
4-24.
4-41.
A
C
Repair information
4-47