Plc Control - Omron NB Series Operation Manual

3
Pressing the [OK] button will make the event information displayed in the event list. After the
event information is logged, you can edit the existing event information by using "Delete" and
"Modify" buttons. Press the [OK] button to complete the log of the Event Information.
For making full use of the communication bandwidth, it is recommended to
use the consecutive bit address block of PLC for the Event Information
component.
For example, you can use the consecutive bit addresses 100 to 199 to control the display of the
event information. And in this case, the data contained in the bit addresses 100 to 199 can be
obtained only by one read command instead of one bit address being read at a time.
3-8-5

PLC Control

When the corresponding control is triggered, PLC Control component can activate one
specific operation.
PLC Control component is a powerful component group, which can realize a large variety of functions
because it is more powerful than the general component. And its functions are as follows:
(1) Change Window: Changes the current window.
(2) Write Data to PLC (Current Base Window): Transfers the current Window No. to the PLC.
(3) General PLC Control: Realizes the data transmission between the PLC address and LW/RW.
(4) Backlight Close: Turns off the backlight.
(5) Backlight Close (Write Back): Turns off the backlight with the returned value.
(6) Execute Macro Program: Executes the corresponding Macro program number when the condition
is met.
(7) Backlight Open: Turns on the backlight.
(8) Backlight Open (Write Back): Turns on the backlight with the returned value.
(9) General PLC Control (Extend)
(10) Change Window (Ignore the window 0)
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
3 Functions of NB-Designer
3
3-247