Omron NB Series Operation Manual page 194

Pause-Clear The default Word Length is 2. "Pause" function only stops to refresh the changes in the curve
temporarily, and the sampling operation will not be stopped temporarily. When "Pause-Clear" is
checked as shown blow, and the state of the specified bit address LB0 is set "ON", the screen will
stop refreshing temporarily When the specified bit address LB0 is set "OFF", the changes in Trend
Curve will be refreshed and displayed.
"Clear" corresponds to the address after the Pause Address. As shown above, the specified bit
address LB0 and LB1 function as "Pause" and "Clear", and the displayed Trend Curve screen can
be cleared only the changes occurred in LB1 state.
SCRO The default value is 3. For example, if the specified register is LW0, LW0, LW1 and LW2 will be the
current browsing index value, the starting browsing index value and the maximum browsing index
value of Scroll Bar respectively. This option is valid only when "Multiple pages" is selected. "SCRO"
can be used to browse the multiple Trend Curves and can be in combination with the Scroll Bar.
For the specific using method of Scroll Bar, refer to 3-6-22 Scroll Bar.
Time It is used to save the time when the latest sampling point is performed. "Time" option in "Control
Register Setting" is valid only when the "Save Time" is checked. The default register is LW and the
Word Length is 12.
As shown above, when the specified address is LW70, the "Second, Minute, Hour, Day, Month,
Year" for the start point in the current page is "LW70, LW71, LW72, LW73, LW74, LW75"
respectively, and the "Second, Minute, Hour, Day, Month, Year" for the end point is "LW76, LW77,
LW78, LW79, LW80, LW81" respectively.
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
Descriptions of Trend Curve Attributes
3 Functions of NB-Designer
3
3-153