Data Transmission - Omron NB Series Operation Manual

5
[Save] & [Compile] or [Offline Simulation]/[Direct Online Simulation]/[Indirect Online
Simulation]/[Download] to the HMI are OK and the final effect is as shown below.
The system reserves LB9020 to LB9022 for the control and notation of the pen, the selections
of Eraser and Clear Block, LB9030 to LB9032 for setting the pen thickness, LB9006 for setting
the operation mode of Note Pad, LW9007 for setting the pen thickness and LW9008 for
selecting any one of 256 colors. For the details, refer to 3-11 Address of System Reserved
Register.
Note 1 Each HMI can only use one Note Pad component. If there are more than one Note Pad components, the
contents in them are consistent because they share the same memory area.
2 The data in the Note Pad will not be saved, i.e. be lost, when the power of HMI is OFF. Please don't write
the information to be registered on the Note Pad.
3-7-8

Data Transmission

Data Transmission component can make the data in the specified register address
transferred to the other register address. Data Transmission can be triggered by the manual touching
method or the state change of the specified address.
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
3 Functions of NB-Designer
3
3-215