Timer - Omron NB Series Operation Manual

3 Functions of NB-Designer
3-7-4

Timer

Timer is a kind of component performing the timing. When the timing is over, it will play the
other corresponding functions such as periodical Macro instruction execution, parameter setting and
data transmission etc.
Process of adding the Timer
1
First press the Timer icon before dragging it into the window, and go to [Timer] tab after the
[Timer Component Attribute] dialog box pops up.
Trigger
Mode
3-206
Descriptions of Timer Attributes
All time With this triggering mode, the timer will be triggered once it is
initialized, and it will stop automatically after the value set in "Repeat
Count" being reached until the next initialization. "Repeat Count" set
to "0" means the timer will always be triggered.
Initial frame The timer will be triggered during the window initialization and it will
stop automatically after the value set in "Repeat Count" being
reached, and will not be triggered any more. The effect of this function
is almost the same as that of "All time".
Close frame Function operation will be triggered once when the window where the
timer component locates is closed.
By reg-address Triggering is executed according to the setting of "Trigger State" and
the value of "Trigger Address". When the triggered times is "0", the
triggering will be executed consecutively until the triggering condition
is cancelled. When the triggered times is "N", the triggering register
will be cleared once the timer is triggered, and it will stop
automatically after the triggering is executed for N times.
NB-series Programmable Terminals NB-Designer Operation Manual(V106)