Omron NB Series Operation Manual page 83

3 Functions of NB-Designer
The following dialog box will pop up automatically.
Here, the name and descriptions of the Source HMI cannot be altered, while the pull-down box of the
Destination HMI lists all the supported HMI type, and the descriptions displayed at the lower part will be
updated automatically according to the type selected by the user. After being confirmed, the HMI will be
replaced, and all the graphics in the HMI will zoom automatically according to the resolution of the
screen.
After the HMI is replaced, the original user edit screen will be adjusted by related scales according to
the difference of the resolution of various types. All the components with screen display will adjust
automatically. For example, all the components (such as the bitmaps, vector graphics, button and lamp,
etc.) with location and size adjustments can all change their sizes automatically. However, note that
there are a few exceptions: as the font size of text and tag can't be changed, the components using text
and tag will be restricted to mainly display the text in the minimum display area when size changes,
especially when it becomes smaller as square components like the meter change sizes in a "square"
way, the changed sizes may disrupt the proportion among the component sizes, therefore it requires a
second fine-adjustment by the user.
If [Special window settings] is used, the special window will be replaced by one that matches the
Destination HMI. If the [Special window settings] is not used, the special window of the source HMI will
continue to be used.
If the resolutions of the source HMI and Destination HMI are the same, no adjustment is required. But
on the contrary, if they are different, it will require the user to adjust the fonts and pictures to appropriate
sizes.
3-42 NB-series Programmable Terminals NB-Designer Operation Manual(V106)