Freeplotting - Omron NB Series Operation Manual

3 Functions of NB-Designer
3
Make settings in the [Tag], [Graphics] and [Control Setting] tabs by using the similar method for
the components mentioned above.
4
Press the [OK] button to complete the setup, and adjust the position and size of the Data
Transmission component.
3-7-9

Freeplotting

The Freeplotting component is based on the data in the register, and you can use it to
draw the corresponding graphics by the pixel point in the HMI.
Freeplotting Component Attribute
1
Solid color with Bit Register used:
Set the component size to 50×50, the register address to LB0, the foreground color to red and
the values of 2500 registers (i.e. LB0 to LB2499) to be read by HMI. Then when the register
value is 1, the pixel point corresponding to the component location will be drawn into red color.
3-218 NB-series Programmable Terminals NB-Designer Operation Manual(V106)