Omron NB Series Operation Manual page 391

3 Functions of NB-Designer
Find Range
Refers to the content of the edit screen in NB-Designer to be searched, and it is classified into 4
kinds, as shown below.
Find Range Current Project
Background
Database
All HMI
Current HMI
Find
Register Register Type
Addr. Type
Text Not checking "Match Case" and "Full Match" means the judgment of the case of the characters
and the consistency in the whole text will not be done during the search.
Match Case
Full Match
Replace
After this option is set, the device type and address found according to the set conditions will be
replaced by the specified device type and address.
"Automigration by Cor. Address" in the Replace part will take effect once the "Range" in Find part is
checked. If "Automigration by Cor. Address" is not checked, the replace address is the same; while if
"Automigration by Cor. Address" is checked, the replace address is the consecutive address which
will automatically deviate by making the set replace address as the start address.
When the above parameters are set, if the "Find" button in the dialog box is clicked, the search of
address meeting the condition will be performed the window locating in the Find Range. If the
component is found, then No., Location, Name and Data will be displayed in the bottom white box.
When the component meeting the requirements is found, the screen will automatically switch to the
position where this component locates and the attribute dialog box for this component will pop up
after this component is double-clicked.
Clicking "Replace" or "Replace All" means the found component meeting the conditions will be
replaced by the component with the address type and address set in the "Replace" part.
All in all, clicking "Replace All" in the above dialog box means all the MW0 components in all the
windows at the current edit screen will be replaced by MW10.
3-350
Descriptions of Find Range
All the Frames, Macros and background database in HMI will be searched.
Only the background components such as Event Information, Alarm Information
and Trend Curve etc. will be searched.
Frames and All the Frames and Macros in the current project will be
Macros searched.
All Frames All the Frames in the current project will be searched.
All Macros All the Macros in the current project will be searched.
Frames and All the Frames and Macros in the selected HMI will be
Macros researched.
All Frames All the components in all the Frames in the selected HMI will
be searched.
Current Frame All the components in the current Frame in the selected HMI
will be searched.
All Macros Only all the Macros in the current HMI will be searched.
Descriptions of Find Type
It means to find the device with Bit type or Word type.
It represents the device type and device address in the controller where the
search is performed. Checking "Range" means the search will be performed in
the set range of address.
It means the match of the case of the characters in the text to be searched is
required.
It means the match of the text to be searched in the whole text is required.
NB-series Programmable Terminals NB-Designer Operation Manual(V106)