Omron NB Series Operation Manual page 193

3 Functions of NB-Designer
Property Start from Top
Start from Bottom
Sampling Time sampling
Methods
OFF ON trigger
sampling
ON OFF trigger
sampling
OFF ON trigger
sampling
OFF ON reset
trigger sampling
ON OFF reset
trigger sampling
Cycle Refers to the interval between 2 sampling points with the unit of "s" or "100 ms".
Sam. Type Continue
Once
Sampling Refers to the number of sampling point displayed in each screen.
Points
PageNum This option is valid only when "Multiple pages" is selected.
Channel Refers to the number of the track line to be displayed. And the channel can be set is up to 16.
Trigger It is valid when "Trigger sampling" is selected as "Sampling Methods". As shown below, when the
Register state change of the specified LB100 conforms to the settings in Sampling Methods, the sampling
will be triggered.
Setting
3-152
Descriptions of Trend Curve Attributes
Y
O
X
X
O
Y
The data is sampled periodically.
When the state of the specified bit register address turns ON from OFF, the
sampling is triggered.
When the state of the specified bit register address turns OFF from ON, the
sampling is triggered.
When the state of the specified bit register address changes, the sampling is
triggered.
When the state of the specified bit register address turns ON from OFF, the
sampling is triggered, and the state of the specified bit register will be reset
automatically after the triggering.
When the state of the specified bit register address turns OFF from ON, the
sampling is triggered, and the state of the specified bit register will be turned
ON automatically after the triggering.
When all the sampling points end, the sampling still continues.
When all the sampling points end, the sampling will stop, which means
sampling is only performed once.
NB-series Programmable Terminals NB-Designer Operation Manual(V106)