Omron NB Series Operation Manual page 75

3 Functions of NB-Designer
Directions:
1
Connector
Just click "Serial Port", and drag it to the Project Structure Window.
2
HMI
Check your HMI type, find and drag the HMI with the same type in the "HMI" to the Project
Structure Window.
3
PLC
Check your PLC type, find and drag the PLC with the same type in the "PLC" to the Project
Structure Window.
After finishing selection of the PLC, HMI and Connector, carry out connection. The connection
method is as follows: move the locations of HMI and PLC accordingly, or click one end of the
connection line and drag it to the vicinity of the COM port of the PLC or the HMI, then bring the
connection port close to either end of the connection line, and a successful connection can be
completed.
Note If the PLC or HMI is not dragged into the "Project Structure Window", both of the "Project Files Windows" and
"Project Structure Window" will be empty, as shown below.
3-34
HMI and PLC is
empty
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
HMI and Vector
Graph is empty