Multiple State Display - Omron NB Series Operation Manual

3 Functions of NB-Designer
In addition, place 2 Number Input components with the addresses of LW15 and LW16 respectively as
well as 1 Number Display component with the address of LW5.
When LW15 is 10 and LW16 is 100, LW5 will increase by 10 each time when "Set" is pressed until the
upper limit (i.e. 100) is reached and then stop increase.
Perform the offline simulation and the effect is shown as below.
3
Switch to the [Tag] tab and add the text describing the state.
4
Switch to the [Graphics] tab and select vector graphics or bitmap to display the bit address
state and represent the touching area.
5
Switch to the [Control Setting] tab and make the Security Setting and set the Notifications.
6
Press the [OK] button to complete the setup of the Multiple State Setting component.
3-6-5

Multiple State Display

Multiple State Display component will display the mapping state according to the value of
the specified word address. If the value is 0, the graphics for the state corresponding to value 0 will be
displayed; while if the value is 1, the graphics for the state corresponding to value 1 will be displayed
and so on. If "Use Tag" is checked, the tag content corresponding to the state will be displayed.
3-92 NB-series Programmable Terminals NB-Designer Operation Manual(V106)