Omron NB Series Operation Manual page 54

3 Functions of NB-Designer
Layer
When the multiple components are overlapped together, you can use the icons shown as
(Set Top Layer, Set Bottom Layer, Previous Layer, Next Layer) or select [Set Top
Layer], [Set Bottom Layer], [Previous Layer], [Next Layer] in [Layer] of the [Edit] menu to change the
display order of the components.
Firstly select the component and set the layer of the component by pressing the corresponding icon.
The component in the front layer is always displayed above that in the back layer.
Set Top Layer
Group/UnGroup
This function is used to make the multiple selected components or graphics combined together as a
3
separate component. To make multiple components combined together, it just needs to select these
components, and then select [Group] in the [Edit] menu or press icon. To cancel the
combination, it only needs to select this combined component, then select [UnGroup] in the [Edit]
menu or press icon.
Same Horizontal Space
This function is used to make the horizontal space between the multiple selected components or
graphics same. Select the graphics or components to be operated, and then select [Same
Horizontal Space] in the [Edit] menu or press icon. The effect is shown as below.
Same Vertical Space
This function is used to make the vertical space between the multiple selected components or
graphics same. Select the graphics or components to be operated, and then select [Same Vertical
Space] in the [Edit] menu or press icon.
NB-series Programmable Terminals NB-Designer Operation Manual(V106) 3-13