Merging Applications - Ricoh B205 Service Manual

MERGING APPLICATIONS ON ONE SD CARD

1.2.2 MERGING APPLICATIONS

Do this procedure to put more than one application on one SD card.
This procedure shows you how to move the DOS application to the PS3 SD card.
1. Turn off the copier.
2. Remove the SD card slot cover ( x2).
3. Put the Source (DOS) SD card in C3. This card contains the application that
you want to copy.
NOTE: The PS SD card cannot be the source card because it cannot be
copied.
4. Put the Target (PS3) SD card in C2. The application on the card in C3 will be
copied to this card.
5. Open the front door.
6. Turn the copier on.
7. Go into the SP mode and select SP5873 001.
8. Touch "Execute".
9. Read the instructions on the display and touch "Execute" to start copying.
10. When the display tells you copying is completed, touch "Exit".
11. Turn the copier off.
12. Remove the Source SD card from C3. Keep the target SD card in C2.
13. Turn the copier on.
14. Go into the User Tools mode and check that all the applications on the SD card
in C2 are enabled:
User Tools> System Settings> Administrator Tools> Firmware Version> Next
15. Turn the copier off again, then:
• Attach the SD card slot cover.
• Attach the rear cover of the machine.
Important!
• After an SD card is copied, it cannot be used. But it must be kept by the
customer, to serve as proof of purchase by the customer.
• The original card can also be used to perform an undo procedure (SP 5873
002). Before you store the card in a safe place, label it carefully so that you
can identify it easily if you need to do the undo procedure (see the next
page).
B767/B846 4 SM