Ricoh B205 Service Manual page 656

6. Remove the application cover [A] of the
controller ( x 1)
7. Remove the cover plate [B] ( x 2).
8. Remove the left scanner cover [C]
( x 1) and the cover below the
scanner [D] ( x 2).
Do the procedures below for either the
single-port or dual-port unit.
Single Port
1. Attach the G3 Unit [A] to the back of
the mainframe ( x 3).
2. Connect the harness [B], red stripe up,
to the CCU I/F board ( x 1)
NOTE: Attach the end of the
harnesses without the clamp to the
CCU I/F, red stripe to left.
3. Fasten the ground wire [C] ( x 2).
4. Attach the plate [D] ( x 2).
B766
G3 INTERFACE UNIT B768
[A]
[D]
[C]
Single Port
6
[A]
[B]
B766I101.WMF
[C]
[D]
B766I103.WMF
[B]
B766I916.WMF
SM