Ricoh B205 Service Manual page 692

System Switch 0A
No FUNCTION
0 Automatic port selection
0: Disabled, 1: Enabled
1-2 Not used
3 Continuous polling reception
0: Disabled 1: Enabled
4 Dialing on the ten-key pad
when the external telephone is
off-hook
0: Disabled 1: Enabled
5 On hook dial
0: Disabled 1: Enabled
6-7 Not used
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E
No FUNCTION
0-1 Not used
2 Enable/disable for direct
sending selection
0: Direct sending off
1: Direct sending on
3 Action when the external
handset goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the same)
4-7 Not used
B766
COMMENTS
When "1" is selected, a suitable port is automatically
selected if the selected port is not used.
Do not change these settings.
This feature allows a series of stations to be polled
in a continuous cycle. This will continue until the
polling reception file is erased.
The dialing interval is the same as memory
transmission.
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when
the external telephone is not by the machine, or if a
wireless telephone is connected as an external
telephone.
1: The user can dial on the machine's ten-key pad
when the handset is off-hook.
0: On hook dial is disabled.
Do not change the factory settings
COMMENTS
Do not change the settings.
Direct sending cannot operate when the capture
function is on during sending. Setting this switch to
"1" enables direct sending without capture. Setting
this switch to "0" masks the direct sending function
on the operation panel so it cannot be selected.
0: Manual tx and rx are possible while the external
handset is off-hook. However, memory tx is not
possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory tx operation.
Note that manual tx and rx are not possible with this
setting.
Do not change these settings.
42
BIT SWITCHES
SP No. 1-101-011
SP No. 1-101-015
SM