Correcting Trapezoid Images
Procedure 1: Minor Adjustment of the Fusing Unit Height (front-to-rear)
1. Print out the SP2-902-003 Trimming Pattern (value: 10).
2. If the image is a pattern A trapezoid:
1) Remove and reinstall the Fusing Unit.
2) Tighten the left fixing screw while you push up the unit's left side (until it
stops).
3. If the image is a pattern B trapezoid, do the same for the unit's right side.
4. If the image is still printed out as a trapezoid, do Procedure 2 below.
SM
4-29
IMAGE PROBLEMS
B205/B209/D007/D008