BIT SWITCHES
I-fax Switch 01
No
FUNCTION
Original Line Resolution of TX
Attachment File
0
200x100 Standard
1
200x200 Detail
2
200x400 Fine
3
300 x 300 Reserve
4
400 x 400 Super Fine
5
600 x 600 Reserve
6
Reserve
7
mm/inch
This setting selects mm/inch conversion for mail transmission.
0: Off (No conversion), 1: On (Conversion)
When on (set to "1"), the machine converts millimeters to inches for sending mail.
There is no switch for converting inches to millimeters.
NOTE: Unlike G3 fax transmissions which can negotiate between sender and receiver
to determine the setting, mail cannot negotiate between terminals; the
mm/inch selection is determined by the sender fax.
When this switch is Off (0):
• Images scanned in inches are sent in inches.
• Images scanned in mm are sent in mm.
• Images received in inches are transmitted in inches.
• Images received in mm are transmitted in mm.
When this switch is On (1):
• Images scanned in inches are sent in inches.
• Images scanned in mm are converted to inches.
• Images received in inches are transmitted in inches.
•
Images received in mm are converted to inches.
SM
COMMENTS
These settings set the maximum resolution of the
original that the destination can receive.
0: Not selected
1: Selected
If more than one of these three bits is set to "1", the
higher resolution has priority. For example, if both
Bit 0 and Bit 2 are set to "1" then the resolution is
set for "Bit 2 200 x 400.
49
SP No. 1-102-002
B766