Ricoh B205 Service Manual page 239

2993* ISSUER CODE Ref
Sets the standard issuer code, once it has been determined. South Korea Only.
[0~9999 / 0 / 1]
2994* Vts Limitation - Factory
2994 1 Upper Limit - Factory Only
2994 2 Lower Limit - Factory Only
2995* ID Sensor Detection Interval
2995 1 Warming-up
This SP controls the temperature at which the ID sensor pattern is created after
the machine is turned on, or after the machine returns to full operation from the
energy saver or auto off mode.
[0 ~ 255 / 30 / 1 degree]
2995 2 Number of Pages
The machine makes an ID sensor pattern after the specified number of prints has
been made.
[0 ~ 999 / 300 / 1 page/step]
2996 Transfer Roller Cleaning
These SP codes determine how the transfer roller is cleaned.
2996 1 0:OFF 1:ON
Selects whether the transfer roller is cleaned. Transfer roller cleaning is necessary
only when black spots occur in the image areas of copies. This can occur when
bad environmental conditions increase the toner density.
Set this to '1' when dirty background appears on the reverse side of the first page
of a copy job. However, the first copy time will be longer regardless of the SP2996
001 setting.
[0 = No / 1 = Yes]
2996 2 Interval
This SP sets the page interval for transfer roller cleaning when SP2996 001 is set
to "1" (Yes). Increase this setting only when absolutely necessary. A higher setting
increases wear on the PCU.
[0~100/50/1 sheets]
Note
• This SP does not execute for the first copy after power on or when the machine
returns from the energy save or auto off mode.
• This SP setting does cannot correct poor copies if there is a problem with the
TD sensor.
2997* Standard Vt (Factory Only)
SM
SERVICE PROGRAM MODE
DFU
DFU
DFU
5-25 B205/B209/D007/D008